Did They Replace All The Original Oxycontin With This New Crush Resistant Formula? (Page 5) (Top voted first)

I heard that all the pharmacy replaced all the original oxycontin (OC) with this new formula that prevents anyone from crushing it. The new pills says OP on the one side instead of it saying OC. And if you still can get the original oxycontin (OC) do you now need to request it from your doctor so he can write you a prescription for the original oxycontin (the pill that says OC on one side instead of it saying OP

REPLY

REPORT

Now, I have nothing against those who choose to abuse Oxy or any other pharmaceutical drug because it is frankly none of my business. We have been trying to stop drug use for over a century and lets face facts, if people want to do drugs then they will find a way. Anyways, SWIM has found a way to cut the binders and make these new OPs ready for abuse. Keep in mind this can also be used for those of you who are not wanting to shoot or snort them. While this process is somewhat tedious, the end result is a higher grade of pain medication. I am not sure if the majority of posts on this Web site are from people who are actually suffering from side-effects which resulted from the new formula or they are genuine addicts who are looking to beat Purdue's new menace. Regardless here are the steps to beating the block (THIS ACTUALLY WORKS, IT MAY SOUND WEIRD BUT BELIEVE SWIM, I WATCHED THEM DO IT.):

Step 1: Use a damp paper towel, or similar, to remove the outer coating. Remember to dry pill rather quickly.

Step 2: Use a grinding tool, preferably an unused PediPaws (NOT A PED EG as stated in an earlier post, this just doesn't work nearly as well). Grind the pill onto a ceramic plate, grind the pill so it goes away from you and onto the plate. Takes a few minutes. (PILL MUST BE GRINDED AND NOT CRUSHED DUE TO NEW FORMULA)

Step 3: Spread the ground up pill evenly as possible on the plate. You almost want an even layer of pill throughout.

Step 4: Place the plate in the microwave and set for 3-5 minutes (TIME WILL VARY WITH MICROWAVE STRENGTH). For new people, you might want to check it at about 2.5 minutes just to be sure you are not melting or burning the pill. Also, having a see-thru window helps, as you may monitor the pill's progress. WHAT YOU ARE LOOKING FOR IS AN END RESULT OF YELLOW POWDER. THIS IS VERY IMPORTANT TO THE PROCESS. The entire pill powder must be yellow for this to work. So just be sure to find the perfect median point of turning yellow without burning.

Step 5: Scrape powder up with credit card (or similar). Now supposedly the pill may be snorted in this form, however, SWIM was not doing this to snort it, rather to IV.

If you are not choosing to IV the powder then you are done. The heat destroyed the binders in the pill and it can now be taken orally and will have results similar to the old formula, possibly with 5-10 mgs less due to heat but this is of course pure assumption. SWIM said it feels like the old 80s if not better, however SWIM was high when he said that. But at least this provides some hope that the process does in fact work.

FOR IV PURPOSES:

Now for those of you wanting to feel the rush here is the final steps.

Step 6: Heat water in spoon, prior to adding powder, this will not only help decontaminate the water but will also aid in the following steps. Bring about 120 units of water to a boil in spoon and then put lighter away as you will no longer need it. (You use 120 units because the pill and heat will reduce it to about 90-100 units)

Step 7: Now, add the powder a little bit at a time, stirring as you go. Keep in mind, the solution will not be clear. So if this bothers you then I suggest you just swallow it. Believe SWIM though, even though it is a little thick and yellow, it is fine he says.

Step 8: Because most of us are not chemists, micron filters are probably not readily available. Therefore take a cigarette butt and use that as you normally would. NO COTTON SWAB, this causes cotton fever. Now hopefully you have a syringe with a removable needle tip (these can be found in the .5ml insulin syringes but not in 1 ml 100 unit syringes). If you don't have a tip that comes off then it will take a while to draw up through the filter, but have patience it will happen (about 10-15 minutes). If you do have removable tip, take it off and place a piece of filter almost into the opening, not all the way because you don't want it to suck in when drawing. Draw up the solution, it won't take long with this method, and pour into a separate spoon. (WHILE MOST LIKE TO SKIP THIS STEP, IT IS WORTHWHILE).

Step 9: Repeat step 8, drawing the liquid up through a fresh filter. Now, you could theoretically repeat this step but two is enough. At this point you should reattach your needle tip and well, you know the rest.

REPLY

Was this helpful? 5

I have multiple sclerosis and battle cancer and they work just fine for me.. You know damn well if you abuse them and you're not admitting it. So cry me a river.

REPLY

Was this helpful? 0

who has any OC 80s I live in Florida what is the closest Pharamacy to me ## Hello, Robert! How are you? I'm sorry, b...

2 REPLIES

is Oxycontin going back to their old formula? OC instead of OP. ## At this time, Purdue has no plans to return to the or...

636 REPLIES

I am not a big fan of the formula change but find the op oxycontin to still work on my chronic pain. The main thing I no...

2 REPLIES

Is there a brown colored pill for the 60mg oxycontin OP... my new Prescription is brown with the number 60 on one side a...

7 REPLIES

I have a friend here in Florida who's mother is still getting 80's original formula. I seen the bottle which was...

8 REPLIES

I was on oxycodone, 40 mg. and live in N.J.. The pharmacy's are telling me that as soon as they run out of it , it w...

31 REPLIES

can anyone give me some help about why my 2m xanax for the past two refills are no longer having the same effect it used...

11 REPLIES

I know my maroon/brick red color 60 mg oxycontin was replaced with a VERY believable look alike by a so called friend an...

I got my Oxycontin (name brand) today and thought i had gotten the generic because it had OP imprinted on it instead of ...

84 REPLIES

I have been taking oxycontin for years for chronic back pain. Now I can't get any relief from pain because of the ch...

7 REPLIES